Раздел: Документация
0 ... 2 3 4 5 6 7 8 ... 15 Chapter 2-3. RECALL PRESETS To call preset, please follow the following instructions: • Press Preset button to enable the calling preset mode. The blinking "Preset" text on live monitoring screen indicates that PDR-3160 is in Preset mode. • I n Preset mode, preset 01 to 16 directly to recall preset points of the PTZ PRESET The above operations can apply to full screen mode as well as multi-channel split modes. device.    Chapter 3. RECORDING Chapter 3-1. START RECORDING To start recording, press REC button on keypad or remote controller. The red recording icon shows on monitor at each cameras position, and the REC LED goes on. Chapter 3-2. STOP RECORDING To stop recording, press REC button again to stop the recording operation. Both REC button and REC LED go off. The recording operation for all the recorded cameras is disabled. Chapter 3-3. EMERGENCY RECORDING Recording operation can be triggered by external alarm switch. There are up to 16 external alarm switches that can be installed for cameras. External alarm switches can be triggered and inform PDR-3160 for emergency recording. Proper settings such as Alarm Rec Duration and activation type (N/O or N/C) should be configured before this operation. Once one of the alarm switch gets triggered, the alarm icon (yellow bell), shows on monitor at the bottom of each camera channel. Chapter 3-4. MOTION DETECTION RECORDING Motion detection is very important feature of PDR-3160 that the intrusion detection of a cameras view can be detected. Motion detection recording sensors motion variation, and it triggers PDR-3160 to perform recording task. Once motion detection is in active, the motioned channel activates an alarm symbol (little man in yellow) on the screen to inform users. Chapter 3-5. SCHEDULE RECORDING Schedule recording allows a user to define the specific time period for recording on a weekly basis. The specific recording period can also be enabled or disabled. One can preview the record scheduling table at Setup - Record - Schedule. PDR-3160 performs recording operation based on the scheduling table.  Chapter 4. PLAYBACK SEARCH To playback, please press play button on remote controller or keypad. A Play message with four different ways box shows up for searching video clips containing time search, event search, rec search, and play entire HDD. Each of the function is described in the following sections: PI AY  SET *+SELECT t+MUUE ESC EXIT Chapter 4-1. TIME SEARCH (M+S) Time search (master + slave) feature can perform date and time search based on recorded video data. This feature is very easy-to-use, and it allows a user to perform video searching task throughout two hard disk drives. The stored video clips are shown in red in the date/time bar. Yellow blocks indicate that there is no video clip stored. On the other hand, the red blocks indicate that there are video clips exist. TIME SEARCH  • To perform the searching, simply press Left or Right button and move the cursor above the red block at desired date and time specified. • Press Enter to choose the date and time information • Press Up or Down to setup year, month, date, hour, and minute. 0 ... 2 3 4 5 6 7 8 ... 15
|
